12v wire feed motor for Clarke® MIG 180EN welders. The wire feed motor measures 37 mm (1-29/64") in diameter and 63 mm (1-1/2") in length. The diameter of the pinion measures 8.7 mm (11/32"). Two screws hold the motor in and are set about 23 mm apart.
PLEASE NOTE: We do not accept returns on electrical parts. If your current wire feed motor does not run, the issue may be the motor or the circuit board. To test the motor, power the motor with a 12v (at least) power source such as a car battery or a battery charger. If the motor does not turn when connected to a 12v power source, then you need to replace the wire feed motor; if the motor does turn when connected to a 12v power source, then you may need to repair or replace the circuit board.
CA Prop 65 - For Residents of California
Warning: Welding and cutting equipment, accessories, and fumes can expose you to chemicals, including Chromium (Hexavalent Compounds), Lead, and Nickel, which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information, please visit www.P65Warnings.ca.gov.