Your choice of torch, 10ft ground clamp, 220v to 110V adapter cord
Does Not Include:
Welding Cart and Air Dryer
The MicroCut® 45 DV is the newest machine added to the HTP® lineup. What is new about this machine? CNC capabilities come standard, Dual Voltage machine, lighter weight, and an LCD Display!
*Please select what torch you would like below. You can choose from a hand cutting torch or CNC machine torch below.*
We have thoroughly tested the MicroCut®45 DV on its precision and duty cycle. While running on 220V it will output a maximum 45 amps; on 110V it will output 25 amps. This machine is not approved for use with a generator. Hand cutting or CNC cutting this machine is sure to meet your expectations. Maximum severance cutting capacity is 1 inch, maximum quality cutting is 3/4".
With the MicroCut® 45 DV, the maximum rated CNC pierce capacity is 1/2"; the cut speed at 1/2" material thickness runs at 16 IPM. To use your MicroCut® 45 DV on your plasma table, simply install your CNC machine torch, plug in your table, and switch the cutter into CNC mode. The MicroCut® 45 DV DOES NOT include the 14-Pin Mating Connector (P/N 64672).
**NOT APPROVED FOR USE WITH GENERATOR**
The MicroCut® 45 DV packs powerful performance into a lightweight design. Thick or thin, the MicroCut®45 DV gets the job done! Backed by a 2-year warranty and a 30-day money back guarantee.
To get the best cutting capacity, fastest cutting speeds, and longest consumable life out of your CNC plasma cutting applications, we highly recommend using our HTP® Max Dry desiccant air dryer system (P/N 25310-2). Dry air is a necessity when running a CNC with a torch height controller.
For torch consumables/parts, please visit the following page: MicroCut®45 DV Hand and Machine Torches and Parts.
If you would like to purchase a hand torch, in addition to the machine torch, please visit the following page: MicroCut® 45 DV Hand Torch.
Warning: Welding and cutting equipment, accessories, and fumes can expose you to chemicals, including Chromium (Hexavalent Compounds), Lead, and Nickel, which are known to the State of California to cause cancer and/or birth defects or other reproductive harm.
For more information, please visit www.P65Warnings.ca.gov.I am very satisfied with the Micro Cut 45 . Mostly use it with my plasma table. Travels easy when necessary,very light. I started out using the hand torch which I thought was fine. Peter Z. suggested that I try the machine torch, the cut is flawless. Good to have both. It is great for gouging as well. I've cut 12 gauge to 1/2" so far and the cut was clean and dross was easily removed. Thanks again
Rates from 0% APR or 10-36% APR. Payment options through Shop Pay Installments are subject to an eligibility check and are provided by these lending partners: affirm.com/lenders. Options depend on your purchase amount, and a down payment may be required. State notices to consumers affirm.com/licenses.
Owner’s Manual
